We all know the feeling: you rush around in the morning, with no smartphone to hand and no clock in sight, as you’ve never found the right one. Well, those days are about to be over! With our special DIY wall clock, your own mementos replace the clock’s numbers. Whether holiday snaps, photos of your loved ones or simply the most beautiful images the web has to offer, there are no limits to your imagination.
What you need
- Templates (e.g. made from paper or cardboard)
- wall plugs
- Carpet knife/cutter
- Clock mechanism
- 0.5 m² corkboard, approx. 5 mm thick
- Photos/mementos (e.g. cinema tickets, holiday photos, flight tickets) for decoration
Let's start - step by step
Mount the clock mechanism
What you need: hammer drill, wall plugs, screws, clock mechanism
After you’ve decided which wall you want to use and how high you want the clock to be, drill a hole in the corresponding spot on the wall. Make sure to check into the wall using a detection device. Place the wall plug in the hole, followed by the screw – but be careful! Don’t screw them in fully so that you can mount the clock mechanism later.
Instead of sticking the photos or mementos to the corkboard, you can also use double-sided tape or pins. This will enable you to be more flexible, as you’ll be able to change the look of your clock whenever you like. If you have an old wall clock lying around, you don’t need to buy a new clock mechanism – simply grab the old clock and remove its mechanism. That way, you’ll just need new batteries. Let’s get started!
Cut the corkboard
What you need: Carpet knife/cutter, Ruler, Pencil, Templates (e.g. made from paper or cardboard)
Now cut 12 equally sized shapes from the corkboard. Use the ruler and pencil to help you. We chose a triangle, but you can also pick squares, circles, stars or hearts – it’s up to you. Once you’re done, mark the centre of each shape. This will help you later on when you’re mounting the DIY clock to the wall.
Mount the wall clock
For perfect alignment on the wall, you should use the cross line laser in self-levelling mode. Point the laser cross precisely at the centre of the clock mechanism. Now turn the minute hand so it points to the 3, allowing you to estimate how much space you will need to enable the clock’s minute hand to move freely. Using the glue gun, glue the first cork shape to the wall. When you’re finished, repeat this step for positions 6, 9 and 12.
Mount the wall clock – Step 2
Now position the cross line laser to 30 degrees to determine the position of the 2, 5, 8 and 11. Again, make sure that the laser is pointed at the centre of the clock face. Now repeat the same steps as before. For the remaining numbers, set the laser to 60 degrees.
What you need: Cordless glue gun, photos/mementos, pins or double-sided tape
Your clock is now professionally mounted! All that’s left for you to do is add your own mementos, photos or favourite prints from the web. If you know you won’t want to change the mementos for a while, you can simply use the glue gun to stick them to the corkboard shapes. However, if you want to keep tweaking your DIY wall clock, we recommend using double-sided tape or pins. No matter how you decorate your clock, one thing’s for sure – no one else will have a clock like it!
Bosch does not accept any responsibility for the instructions stored here. Bosch would also like to point out that you follow these instructions at your own risk. For your own safety, please take all the necessary precautions.