Costs< 50 £
Bring the great outdoors into the comfort of your living room! Logs made from felled trees aren't just good for firewood: you can also use them to make DIY flower pots. Take a look at our step-by-step guide for instructions. We've also listed all the tools you need.
What you need
- work gloves
- face mask
- ear protectors
- protective goggles
- floor protector or cover sheets
- tape measure
- Mortice chisel
- Logs of various sizes: 30–50 cm x 20–30 cm (H x D)
- Clear or matt varnish for wood
- Paint in a colour of your choice
- Cling film for the inner lining
- Drainage material, such as expanded clay
Let's start - step by step
Mark out the dimensions for the DIY plant pots
What you need: Pencil, tape measure, logs
It's easiest to get your logs cut by a carpenter or a timber merchant in your area. Or if you're going to buy your logs at a hardware store, you should also be able to get your wood cut there. It's best to choose logs with different lengths for more variety. Alternatively, you can cut them yourself using a chain saw. If you want to use wood from a tree that has only been felled recently, leave it indoors for a few days to let it dry out sufficiently. Otherwise signs of mould may start to appear on the surface of your DIY plant pot.
Hollow out the log to make an opening for the flower tub
To make a DIY flower pot out of the log, hollow out roughly half of it. The easiest way to do this is to use a large Forstner bit to bore several holes in the log, then hollow out the bits in between to create one big hole. To do this, place the mortice chisel against the wood and tap the end with the mallet to chip away at the inside of the log. You can remove the wood shavings afterwards using a cordless vacuum cleaner.
Remove the bark at the bottom of the log
What you need: multifunction tool, Plunge cut saw blade for wood for the multi-function tool, work gloves, protective goggles
Now the hollowed-out log is starting to look more like a DIY flower pot. Make the outside of the log look nicer by using a multi-function tool and a suitable saw or scraper attachment to remove the bark from the bottom part. When doing so, secure the log against a workbench to ensure that it doesn't slip.
Sand down the bottom part of the log
Varnish your DIY plant pots
What you need: paint spray system, protective paper or film , face mask, disposable gloves, clear or matt varnish, paint in the colour of your choice
Now it's time for the final step. Coat your flower pots in clear or matt varnish to protect the wood. To add a dash of colour, you can also paint the area where you have removed the bark.
It's best to lay a protective sheet on the ground and tape over the parts of the log which you don't want to paint or varnish beforehand. Once you've put on your safety gear, fill the paint spray system with varnish or paint and apply an even coat to the log.
Let it dry thoroughly and then line the inside of the flower pot before adding the first plants. To protect the wood from getting damp, it's best to use cling film or pond liner. And to avoid a build-up of damp in your DIY plant pot after watering, you should add a drainage layer such as expanded clay, which is especially well-suited for indoor plants.
Bosch does not accept any responsibility for the instructions stored here. Bosch would also like to point out that you follow these instructions at your own risk. For your own safety, please take all the necessary precautions.