Costs< 50 €
Duration< 1 h
The floor, your desk chair, the desk itself, your bed – not having the right place to store clothes means they just get moved from one place to the next. This stylish and unique clothing rail puts an end to this clothing merry-go-round. It doesn’t just look great, but you can also easily build it yourself.
What you need
- Bradawl, screwdriver or similar
- Pocket rule
- Protective goggles
- Ear protection
- Protective gloves
- Screw hooks (approx. 30)
- Steel cable
- Wire clips
- Tree branch (for example birch, with or without bark) approx. 1.5 m in length
Let's start - step by step
Cut the tree branch to length and sand it
Get hold of a suitable tree branch. You can look for one while you’re out on a walk or ask a forester. Make sure you check whether you’re allowed to take the branch with you. Once you’ve found the perfect tree branch to make your clothing rail out of, saw it to the desired length. The branch in our example is 1.5 m long. It’s up to you how long you want your hanging clothing rail – and therefore your branch – to be. Secure your branch to your workbench with G-clamps. Use a saw to shorten it and don’t forget to wear protective goggles, ear protection and gloves. Also, remove any twigs and other branches that are in the way. You can sand the rough ends. You should also wear protective goggles, ear protection and a mask while sanding.
Measure out intervals for the hooks
What you need: Pocket rule, Pencil, Bradawl, screwdriver or similar
In this next step, you will measure out the spacing for the screw hooks on the tree branch. Do this by lying the pocket rule on the branch and marking out the intervals. We’ve gone for 5 cm between each hook, but feel free to choose whatever spacing you like. We’ve used a bradawl for the markings, but you can also use a screwdriver or a sharpened pencil.
Drill holes for the hooks
Drill holes for the steel cables to hang the rail
Mark where you want to thread the steel cables through on each end of the tree branch. You can use these cables to hang your clothing rail anywhere in your home. To do this, drill the two holes using a small drill bit (3 mm). Then, use a larger drill bit (8 mm) to enlarge the holes you’ve drilled on the underside of the rail so that wire clips can be fully inserted into them later. How deep you drill the hole using the 8 mm drill bit depends on the size of the wire clip.
Screw the hooks in
What you need: screw hooks
Screw all the hooks into the holes you’ve drilled. Later, you can hang your clothes on them. It’s entirely up to you how many hooks you use.
Thread the wire cables through and seal them
What you need: steel cable, wire clip
Thread the steel cables through the holes and screw down the wire clips so you can hang your DIY clothing rail safely and without a problem. The clips disappear into the larger holes you drilled into the tree branch and can no longer be seen.
You’re almost finished! Now, you just need to hang up your new clothing rail and you’ll have somewhere perfect to show off your clothes. You can do this either with screw hooks or dowels, depending on the material and strength of your wall. Use your cordless drill to drill the holes in the wall you’ll need to safely hang up your rail.
Bosch does not accept any responsibility for the instructions stored here. Bosch would also like to point out that you follow these instructions at your own risk. For your own safety, please take all the necessary precautions.